Charge With Evbox Elvi - EVBOX Elvi Manual Del Usuario

EN

2. Charge with EVBox Elvi

Start charging
1. Plug your charging cable into EVBox Elvi.
2. To start and stop a charging session, you can use a registered charge card, key
fob, or your mobile EVBox Elvi station management application.
3. In case of charge card activation, hold your charge card (RFID Card) in front of
the reader, marked with
4. EVBox Elvi reacts with a beep. This means that your card is being authorized.
5. The EVBox Elvi LED ring turns blue when it starts charging.
Stop charging
1. In case of charge card activation, hold your charge card (RFID Card) in front of
the reader, marked with
2. EVBox Elvi reacts with a beep. This means that your charge card/key fob is
being authorized. The EVBox Elvi LED ring turns green when it stops charging.
3. Unplug your charging cable from EVBox Elvi and place it back into your car.
Alternatively, you can unplug your charging cable from EVBox Elvi directly and
end your session.
What you see
LED ring off
or green
LED ring
green, flashing
LED ring
yellow
LED ring
yellow, flashing
LED ring
blue
LED ring
red
LED ring
red, flashing
8
icon.
icon.
What it means
EVBox Elvi is ready for use.
Your charge card is being
verified.
The car is fully charged.
Charging session is in queue
(applicable in the Smart
Charging environment only).
EVBox Elvi is charging the car.
EVBox Elvi is experiencing
an error.
Your charge card is not autho-
rized to charge.
What to do
Plug the charging cable into EVBox Elvi.
Wait until LED ring turns blue.
Unplug the charging cable from EVBox Elvi and
place it back into your car.
When power becomes available, charging will
start or resume, and the LED ring will turn blue.
The car is charging.
Check the troubleshooting chapter in this man-
ual for solutions. If this does not solve the issue,
contact your installer or supplier of EVBox Elvi, or
write us at [email protected].
Contact your charge card service
operator.