Roger B70/2ML Instrucciones Y Advertencias Para El Instalador página 72

normal.
Selection of the battery operation management
Setting a value different than
parameter and an error alert can be activated through the COR output via parameter
The control unit always accepts commands until the battery is completely exhausted.
The command becomes active when the battery voltage drops to the minimum threshold (22Vdc for battery 2x12Vdc)
The command becomes active when the battery voltage drops to the medium threshold (23Vdc for battery 2x12Vdc)
The command becomes active when the battery voltage drops to the maximum threshold (24Vdc for battery 2x12Vdc)
Restoring factory default values
NOTE: This procedure is only possible is NO data protection password is set.
unit switches on.
• The display flashes after 4 s
• The default factory settings have now been restored.
N.B.: The values shown in the table are indicative only.
HW version
Year of manufacture
Week of manufacture
Serial number
FW version
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
IMPORTANT:
Manoeuvres performed.
Example
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT: "manoeuvre" means every motor opening activation.
The message
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
until is displayed.
If the TEST key is released,
The number of hours
If the value =
Manoeuvre hours.
72
a battery voltage level check is activated. The desired operation type can be selected via
+
P1
P2
x4 s
-
.
x100 = 12.300 manoeuvres.
and
appears on the display and the alarm is not reset.
is stored by the control unit, and the count is reset.
= is exceeded (9990 hours of operation) the maintenance alarm is no longer managed.
= 123 hours.
Warning! Restoring default settings cancels all settings made
previously except for parameter
parameters are suitable for the installation.
The default factory settings may also be restored using the +
• Turn off the power.
•
to
to multiplied by 100.
to .
) is exceeded, the visual maintenance signal is activated (e.g. every
) and press TEST for 5 s. The message
.
.