Acquisition Procedure - Roger B70/2ML Instrucciones Y Advertencias Para El Instalador

TEST
CLOSE
10.2

Acquisition procedure:

PROG
AP P-
x4 s 1 click
x2 s
AU to AU to AU to
•
• Press PROG again. Auto is shown on the display.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter
2 s.
When the message
set with parameter (default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
• acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• travel length error. Press TEST to clear the error, and check that both gate leaves are fully closed before
launching a new acquisition procedure.
For more information, see chapter 14 "Alarms and faults".
27
No
da ta
No
Yes
00
PROG
AU to
2
MOTOR 2 PARAM. 26
CLOSING DELAY TIME
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
TEST
SEE CHAPTER 14 e 15
1 click
TEST PROG
1 click
Press and hold on
TEST
ACQUISITION
PROCEDURE
CHAP. 11.2
1 click
1
MOTOR 1 PARAM. 25
OPENING DELAY TIME
2
1
MOTOR 1 CLOSE
CLOSING
Until...
ACQUISITION
PROCEDURE
AP P-
CHAP. 11.2
2
1
MOTOR 2
OPEN
OPENING
Yes
61