Adjusting The Cutting Angle - Bosch GTS 10 J Professional Manual Original

All manuals and user guides at all-guides.com
OBJ_BUCH-1325-001.book Page 44 Saturday, January 22, 2011 12:54 PM
44 | English
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Mount the clamping flange 44 and the clamp-
ing nut 42.
– Turn the clamping nut 42 with the ring span-
ner 22 (23 mm) and at the same time, pull
the spindle lock lever 43 until it engages.
– Tighten the clamping nut in clockwise direc-
tion. (Tightening torque approx. 15–23 Nm)
– Reinsert the insert plate 24.
– Tilt protection guard 6 down again.
Operation
Before any work on the machine itself, pull
the mains plug.
Transport and Working Position of the
Saw Blade
Transport Position
– Turn the handwheel 18 in anticlockwise di-
rection until the teeth of the saw blade 26
are positioned below the saw table 9.
– Slide the table extension 14 completely in-
ward.
Press tensioning lever 15 downward.
The saw-table extension is now locked.
For additional information on transport, see
page 49.
Working Position
– Turn the crank 19 clockwise, until the teeth
of the saw blade 26 are positioned above the
workpiece.
Note: Take care that the blade guard is properly
positioned. When sawing, it must always face
against the workpiece.
1 609 929 X56 | (22.1.11)

Adjusting the Cutting Angle

To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see "Checking
and Adjusting the Basic Adjustment", page 47).
Adjusting Bevel Angles
(Saw Blade) (see figure K)
The bevel angle can be set in the range from –2°
to 47°.
– Turn locking lever 17 in anticlockwise direc-
tion.
Note: By completely loosening the locking knob,
the saw blade tilts approx. to the 30° position
by means of gravity force.
– Push or pull handwheel 18 alongside the con-
necting link until the angle indicator 47 indi-
cates the desired bevel angle.
– Hold the handwheel in this position and
tighten locking lever 17 again.
For quick and precise setting of the standard
0° and 45° angles, factory-set stops have been
provided for.
Adjusting Mitre Angles
(Angle Stop) (see figure L)
The mitre angle can be set in the range from 60°
(left side) to 60° (right side).
– Loosen the locking knob 49 in case it is tight-
ened.
– Turn the angle stop until the angle indicator
50 indicates the requested mitre angle.
– Tighten the locking knob 49 again.
Increasing the Size of the Saw Table
(see figure M)
Long workpieces must be underlaid or support-
ed at their free end.
– Completely pull tensioning lever 15 of the
saw-table extension upward.
– Pull out the saw-table extension 14 to the de-
sired length.
– Press tensioning lever 15 downward.
The saw-table extension is now locked.
Bosch Power Tools