Safety Valve; Check Valve - DeWalt D2002M Manual De Instrucciones

WARNING: RIsk Of fAllING
WHAt CAn HAPPen
• A portable compressor
can fall from a table,
workbench, or roof causing
damage to the compressor
and could result in serious
injury or death to the
operator.
CAUTION: RIsk fROm NOIsE
WHAt CAn HAPPen
• Under some conditions and
duration of use, noise from
this product may contribute
to hearing loss.
SAVE thESE InStruCtIonS
For FuturE uSE
HoW to PreVent It
• Always operate compressor
in a stable secure position to
prevent accidental movement
of the unit. Never operate
compressor on a roof or
other elevated position. Use
additional air hose to reach
high locations.
HoW to PreVent It
• Always wear certified safety
equipment: ANSI S12.6
(S3.19) hearing protection.
FEAturES
on (I) /off SWItCH (o)
Place this switch (A) in the ON position to provide
automatic power to the pressure switch and
OFF to remove power at the end of each use.
PreSSure SWItCH (not SHoWn)
The pressure switch automatically starts the
motor when the air tank pressure drops below
the factory set cut-in pressure. It stops the motor when the air tank
pressure reaches the factory set cut-out pressure.

SAfety VALVe

If the pressure switch does not shut off the air
compressor at its cut-out pressure setting, the
safety valve (F) will protect against high pres-
sure by popping out at its factory set pressure
(slightly higher than the pressure switch cut-out
setting).

CHeCk VALVe

When the air compressor is operating, the
check valve (I) is open, allowing compressed
air to enter the air tank. When the air compressor
reaches cut-out pressure, the check valve
closes, allowing air pressure to remain inside
the air tank.
8
A
F
I