Troubleshooting Guide; Troubleshooting Codes - DeWalt D2002M Manual De Instrucciones

Compresor de aire de 150 psi máximo con tanque de 6 gal (23 l)

Ocultar thumbs Ver también para D2002M:

Manual de instrucciones (56 páginas)

Manual de instrucciones (24 páginas)

Tabla de contenido

Idiomas disponibles

This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or

maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified D

your dealer.

Problem

Excessive air tank pressure-safety valve pops off ......................................................................1, 2

Air leaks .................................................................................................................................... 3

Air leaks in air tank or at air tank welds .................................................................................... 4

Air leaks between head and valve plate .................................................................................... 5

Air leaks from safety valve......................................................................................................... 6

Knocking Noise .......................................................................................................................... 6

Pressure reading on the regulated pressure gauge drops when an accessory is used ........... 7

Compressor is not supplying enough air to operate accessories.............................................. 8, 9, 10, 11, 12

Regulator knob has continuous air leak .................................................................................... 13

Regulator will not shut off air outlet ........................................................................................... 13

Motor will not run ....................................................................................................................... 14, 15, 16, 17, 18, 19

CoDe

PoSSIBLe CAuSe

Pressure switch does not shut off motor when compressor

reaches cut-out pressure

Pressure switch cut-out too high

Tube fittings are not tight enough