Waeco MAGIC WATCH MWE-1000-4FM Instrucciones De Montaje Y De Uso página 34

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
_MWE-1000-4FM.book Seite 34 Dienstag, 9. August 2005 11:30 11
Safety and installation instructions
When the negative terminal of the battery is disconnected, all data stored in
the volatile memories will be lost.
The following data must be set again, depending on the vehicle
equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
Secure the parts of the MAGIC WATCH system installed in the vehicle in
such a way that they cannot become loose under any circumstances (sudden
braking, accidents) and cause injuries to the occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to emerge once the hole has been made (2, page 4).
Whenever possible, do not mount the sensors directly above the end of
the exhaust. Otherwise errors in the display may result.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(1 5, page 3) or a voltmeter (1 6, page 3).
Test lamps with an illuminant (1 9, page 3) take up voltages which are
too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted,
– They do not rub on edges,
– They are not laid in sharp edged ducts without protection (3, page 4).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
34
magic watch
Tabla de contenido
loading

Este manual también es adecuado para:

Magic watch mw-1000-4fm

Tabla de contenido