Slot Cuts; Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance - HOLZMANN MASCHINEN KAP305JL Manual De Usuario

16.3.3 Slot cuts

Set the depth stop for slot cuts so that the desired cutting depth is obtained at the selected
angle.
Make the mitre or sliding cuts as described in the respective chapter with the difference that the
workpiece is not completely cut through.

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage! Handling at the machine with upright power
supply can lead to serious injuries or death. Always disconnect the machine from
the power supply before cleaning, servicing or maintenance work and secure it
against unintentional reconnection!

17.1 Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
 Therefore, clean the machine after each use and remove any sawdust with a brush, broom or
vacuum cleaner.

17.2 Maintenance

The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
 Before each operation, check that the safety devices are in perfect condition.
 Regularly check that the warning and safety labels on the machine are in perfect and legible
condition.
 Use only proper and suitable tools.
 Only use original spare parts recommended by the manufacturer.
17.2.1

Maintenance schedule

The type and degree of machine wear depend on the operating conditions. The following intervals
apply when the machine is used within the specified limits:
interval components
Saw blade
Saw blade guard
Before usage
Table inlet
Cable
Maschine
After usage Saw blade guard
Chip bag
after 50h (/
Carbon brush
10h)
When
Saw balde
required
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
W A R N I N G
N O T E
activity
Check for damage and replace if necessary.
Check function (see function check saw blade protection)
Check for damage and replace if necessary.
Check for damage and repair if necessary.
Remove dust/wood splinters and dirt
Check and replace if necessary.
Check sharpness of saw blade and replace when
necessary
www.holzmann-maschinen.at 43
KAP305JL