Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Training and Operating Instructions
24
GB
All manuals and user guides at all-guides.com
Training by pulse defaults
(PROGRAM) "HRC1 Count Up"
• Press "PROGRAM" until symbol: "HRC Count Up" flas-
hes.
• Press "SET": Default range
Or
Start
training,
all
Power is increased automatically, until the target pulse is
achieved (e.g. 130)
(PROGRAM) "HRC2 Count Down"
• Press "PROGRAM" until symbol: "HRC Count Down"
flashes.
• Press "SET": Default range
The entries and possibilities for modifications are ana-
logue to program item "Count Down".
Or
Start of training
Note:
In the HRC programs the determination of the initial power
of 25-100 watts is possible in the default range.
• Enter values with "Plus" or "Minus" (e.g. 100)
Power is then automatically increased from 100 watts
on, until the target pulse is achieved (e.g. 130)
Pulse
• The pulse value can still be changed at this point (rea-
diness for training) with "Plus" or "Minus", e.g. from
130 to 131.
Start of training by pedaling.
Comment:
• For HRC programs, KETTLER recommends pulse measu-
rement with the chest strap.
• There is a power adjustment with HRC programs for
deviations of +/– 6 heartbeats.
Interruption or end of training
For less than 10 pedal revolutions/min or pressing "RECO-
VERY", the electronic equipment recognizes an interruption
of the training. The training data achieved are displayed.
Display.
Note:
Speed, revolutions and pulse
are represented as average values with the Ø symbol.
• In this display, no current pulse is available.
With "Plus" or "Minus" the display changes to the remai-
ning values of defaults (here DISTANCE 1.50, ENERGY 87,
TIME 4:09, last set power 125 and current pulse 110.
Display.
The training data is displayed for 4 minutes. If you do
not press any key and do not resume training in this
time, the electronic equipment switches into the
sleeping mode with
POWER
display.
Resume training
values
count
up.
Capítulos
Tabla de contenido
