Bosch GTA500 Instrucciones De Funcionamiento Y Seguridad página 3

BM 2610016588 02-11:BM 2610016588 02-11.qxp 2/22/11 6:50 AM Page 3
1. Unfold stand to open position and flip over
retainer clips 1 as depicted in Fig. 2.
2. Slide table saw onto the stand so that the
rear base 2 slides under the retainer clips
1 (Fig. 3). Make sure the saw base lines
up evenly with the edge of the stand.
3. Once base is aligned, hook the wire 3 from
the clamp on the front of the stand over
the tab 4 located on the saw base and lock
into place (Fig. 4).
Note: To remove the saw from the stand,
follow the same procedure in reverse.
To reduce the risk of
WARNING
personal injury, do not
operate table saw with stand until you have
read and understand the following:
• Do not stand on the table saw stand or use
as a ladder or scaffolding.
• Do not open or close stand with table saw
mounted.
• Do not use table saw if stand tips, slides or
moves in any way.
• Before operating table saw, ensure table is
securely fastened to stand and entire unit
must be placed on solid, level surface.
Mounting Saw to Stand
FIG. 2
FIG. 4
-3-
FIG. 3