Middle Section
•
Do not open the hinge to an angle greater than 90 degrees. Excessive
opening can cause permanent damage to the hinge.
•
If the Ball Receivers are removed, take care not to lose the steel balls.
When reinstalling, make that the steel balls are in the centre of the
coin passage.
Hinge
Ball receiver
1.
Loosen the 8off pozi head screws (M3x10), with flat and spring washers,
and 2off pozi head screws (M3x12) on the two Edge Plates.
Do not remove the screws.
2.
Widen the gap between the Edge Plates and Back Plate, and push jammed
coins with a finger in the direction of the arrow.
Pozi head screw (M3 x 12)
(with spring washers and flat washers)
Pozi head screws (M3 x 10)
(with spring washers
and flat washers)
3.
After coins have been removed, re-assemble in reverse order.
Coin passage
Ball receiver
Page 84
Ball receiver
Steel ball
Ball receiver
Edge plate
Back plate