NAMCO PAC-MAN BALL Manual Del Usuario página 117

4. Disconnect the connector, and remove 4off pozi head screws (M3x6).
5. Remove 2off snap pins and 2off flat washers (M5), and detach the spring.
6. Loosen the double point screws (M4x5), and pull out the block.
7. Remove 1off spring pin (4x16), remove the solenoid plate, and replace the
Solenoid.
8. Re-assemble in reverse order.
• Make sure that one of the double point screws is engaged on the flat of the
Divider (shaft section), and apply Loctite to the threads before tightening.
•
When re-assembling, make sure that the Divider (shaft section) end is flush
with the Block end face.
•
When re-installing, install the Spring Pin so that the gap section is located
at the top.
Snap pins, flat washers (M4)
Connector
Pozi head screws (M3 x 6)
Solenoid plate
Payout solenoid
Spring pin (4 x 16)
Page 117
Double-point screws (M4 x 5)
Divider
(shaft section)
Block
Spring