Battery Charger Configuration; Operating Information; Machine Preparation - Lavorwash FREE EVO 50E Manual De Instrucciones

Battery discharge indicator and functions - MODEL "BT" (DC 24V with traction)
Volts
Battery Type
Pb-Acid
24,0
21,5
20,5
20,0
If you do not complete the configuration procedure,
the settings remain as they were originally.
!
( ) We recommend to call the assistance centre or
a technician if you have problems with the settings
given.
Do not open or tamper the electronic board.

5.2 BATTERY CHARGER CONFIGURATION

!
( ) We recommend to call the assistance centre or
a technician if you have problems with the setting
given.
The machine is equipped with a battery charger
configurated for GEL batteries
If the operator whish to use Pb-Acid battery, it is
necessary change the battery charger settings as
follows:
!
( ) DISPLAY OF THE BATTERY CHARGER SET-
TINGS
The battery charger settings are shown by the
blinking of the LED indicator when the battery
charger is switching on:
- the RED LED indicator ( Photo M - 2 )
flashes 2 times = the battery charger is set for
PB-Acid batteries
- the GREEN LED indicator ( Photo M - 3 )
flashes 2 times = the battery charger is set for
GEL batteries
The battery charger settings will be displayed even
if batteries are not connected.
!
( ) DIP-SWITCH CONFIGURATION FOR PC-
ACID/GEL BATTERY CHARGING CURVE
To set the charging curve type for Pb-Acid or GEL
batteries it is necessary to operate on a dip-
switch placed inside the battery charger (
Battery power
test indicator
LED
GEL Signaling
24,0 Green LED ON
22,5 Yellow LED ON
21,5 Red LED ON
21,0 Red LED
FLASHING
Brush operation
indicator LED
Signaling
LED ON
LED ON
LED FLASHING
LED FLASHING
Photo M -4 ).
The dip-switch available for the setting of the
charging curve is on the control card ( Photo M - 4
) that is placed behind the lower panel of the bat-
tery charger ( Photo M - 1 ). It is also possible to
reach the dip-switch by removing the plastic cap (
Photo M - 5 ).
Starting from left to right, the dip-switch available
for the setting of the charging curve is the first one,
that is indicated by number 1 in dip-switch SW1
( Photo M - 6 ).
Position of Dip-switch
SW1 - number 1
ON
OFF
NOTE: the position of all the remaining dip-switches
must NOT be changed.

6. OPERATING INFORMATION

6.1 MACHINE PREPARATION

!
( ) Before starting to work, wear non-slip shoes,
gloves and any other personal protection device in-
dicated by the supplier of the detergent used or
considered necessary based on the operating envi-
ronment.
☞
( ) Do the following before starting to work. Refer
to the relative sections for a detailed description of
these steps:
Heck the battery charge level and charge, if neces-
sary.
34
ACTION
All working
All working
Brush motor is
not working
All motors are
not working
Charging curve
Charging curve for
PB-Acid batteries
Charging curve for
GEL batteries