T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the rear doors and
remove the threshold trim plate
along the rear edge of the vehicle
(Fig. 1A).
3. Remove the interior trim
panels on each side of the rear
of the van near the rear doors to expose the access ports
beneath (Fig. 1B).
4. Locate the vehicles tail light wiring harness behind
each of the tail light assemblies. The harnesses will have
connectors similar to those found on the T-Connector
harness.
5. Beginning on the left (drivers) side, remove the green
connector lock and separate the vehicle harness ends
by carefully pressing on the locking tab and pulling the
connectors apart, taking care not to damage the locking
tabs.
6. Position the T-Connector harness ends with the Yellow
wires between the separated vehicle harness connectors.
Press the T-Connector ends into the vehicle harness
connectors until they lock into place. Take care not to
damage the locking tabs. Secure the connectors with the
green connector lock removed in step 5. Use a second lock
B
A
