T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail light
wiring harness under the rear
of the truck, behind the bumper
along the frame rails. The harness
will have connectors similar in
appearance to those on the
T-Connector harness.
3. Beginning with the left (drivers) side,
disconnect the vehicle harness connectors.
Check the connectors for dirt and debris and clean if necessary.
taking care not to damage the locking tabs.
4. Position the T-Connector ends with the Yellow wire
between the separated vehicle connectors. Firmly press the
connector ends together until the locking tabs engage. Take
care not to damage the locking tabs.
5. Route the T-Connector ends with the Green wire along the
vehicle frame under the body to the right (passenger) side of
the vehicle.
6. Repeat steps 3 & 4 for the left (passenger) side using the
T-Connector ends with the Green wire.
7. Confirm correct operation with a test light or by using a trailer.
8. Secure the T-Connector's black box to the vehicle frame
or other supporting structure. Secure the trailer plug near the
center of the vehicle bumper with a 6" cable tie.
Fig. 1
