Maintenance And Care - Joycare JC-406 Manual De Instrucciones

GB
TO SET ALARM TIMER
Press T-SET to confirm and go to next digit.
After setting time span, press T-SET to start counting down.
Press any key to stop counting down.
Press T-SET to clear time span.
When timer counts down to "00:00", alarm will start "beeping" for 60 times and
the scale will automatically shut off.
Max.time span: 99:59

MAINTENANCE AND CARE

Place always the product on a flat and stable surface. Please clean the appliance
with a damp and soft cloth avoiding any water seepage inside the scale. Do not use
chemical detergents. Never deep the product into water. Avoid shaking, dropping
or shocking the scale. This is a precision instrument and must be handled with
care. Never try to repair the scale by yourself but always address to specialised
centres; otherwise, the warranty will be not valid anymore. It is advisable to store
the scale in a clean place. Dust, dirt, moisture, vibration, air currents, can all cause
an adverse effect on the reliability and accuracy of your scale.
When the unit is not used for a long period of time, it is advisable to remove
battery, as their leaking can damage the appliance. When the scale is switched off,
never place or lay any objects on it.
In case of malfunction:
Check that the batteries are inserted properly
If problems persist, contact the Service Centre JOYCARE
The product is made conforming with all the applicable
European regulations
DISPOSAL
The device (including its removable parts and accessories) must not be disposed
of together with municipal waste at the end of its life, but in compliance with
European Directive. Since it must be handled separately from householdwaste,
either carry it to a separately-collectedwaste disposal centre for electrical and
electronic appliances or give it back to the retailer on purchasing a new device
with the same purpose. Any infringement will be severely prosecuted.
The batteries used in this device must be disposed of in the special bins at the
end of their life.
Specifications and designs are based on the latest information available at the time of
printing and subject to change without notice.
6