Haier HMV1640 Instrucciones De Instalación página 42

2. Percer un trou aux emplacements du trou A et du trou B.
REMARQUE : Une vis à bois doit être utilisée lors d'une installation sur un poteau
de bois.
•
Percer un trou de 5⁄8" pour utiliser un boulon à ailettes.
•
Percer un trou de 3⁄16" pour utiliser une vis à bois.
3. Si ni le trou A ni le trou B n'a été percé dans un poteau, percer un troisième trou
dans le poteau à l'aide d'un foret de 3⁄16".
4. Retirer la plaque de montage/gabarit du mur arrière et la mettre de côté. NE PAS
MONTER LA PLAQUE À CE MOMENT.
a
Ligne horizontale
b
Zone E
c
Ligne axiale
d
Tracer une ligne horizontale sur le
mur depuis le dessous du "gabarit
du mur arrière".
e
Trou A
40
3/8" TO EDGE
12"
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
4"
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE h
AREA.
i
a
b
c
Trim the rear wall template along the dotted line.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
g
d f
e
f
Ligne horizontale
g
Tracer une ligne verticale sur le
mur depuis le centre du placard
supérieur.
h
Encoches de la ligne axiale
i
Trou B