Step 4 - Drill Holes For Mounting Microwave Oven - Haier HMV1640 Instrucciones De Instalación

STEP 4 - DRILL HOLES FOR MOUNTING MICROWAVE
OVEN
IMPORTANT:
•
Holes A and B are inside area E on the template. If neither Hole A nor Hole B
aligns with a stud, locate a stud within area E and draw a third circle that aligns
with the stud.
•
At LEAST one wood screw mounted firmly in a stud must be used to support the
weight of the microwave.
1. Draw a Horizontal line on the wall at the bottom of the Mounting Plate/Rear Wall
Template.
2. Drill a hole in Hole A and Hole B locations.
NOTE: A wood screw must be used when installing into a wood stud.
•
Drill a 5⁄8" hole to use a toggle bolt
•
Drill a 3⁄16" hole to use a wood screw.
3. If neither Hole A or Hole B is drilled into a stud, using a 3⁄16" drill bit, drill a third
hole into a stud.
4. Remove the Mounting Plate/Rear Wall Template and set it aside. DO NOT
MOUNT THE PLATE AT THIS TIME.
a
Horizontal Line
b
Area E
c
Center Line
d
Draw a Horizontal line on wall from
bottom of "Rear Wall Template".
e
Hole A
10
3/8" TO EDGE
12"
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
4"
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE h
AREA.
i
a
b
c
Trim the rear wall template along the dotted line.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
g
d f
e
f
Horizontal Line
g
Draw a Vertical Line on Wall from
Center of Top Cabinet
h
Centerline notches
i
Hole B