Haier HMV1640 Instrucciones De Instalación página 15

PREPARE OVERHEAD CABINET
1. Read the instructions on the Top Cabinet template, and then tape the template
underneath the overhead cabinet.
2. Drill the holes following the instructions on the template.
•
Drill holes for the top support screws.
•
Drill a hole large enough for the power cord to fit through.
•
Drill a cutout large enough for the exhaust adaptor.
ADAPT BLOWER FOR OUTSIDE TOP EXHAUST
1. Place the microwave in its upright position, with the top of the unit facing up.
2. Remove and save the screw fastening the blower plate to the microwave.
3. Remove and save the screw fastening the blower motor to the microwave.
a
4. Carefully pull out the blower unit. The wires will extend far enough to allow you to
adjust the blower unit.
a
5. Roll the blower unit 90° so that fan blade openings are facing out the top of the
microwave.
Before Rotation
6. Place the blower unit back into the opening.
b
c
c
After Rotation
a
b
a
Blower Plate Screw
b
Blower Plate
c
Back of Microwave
d
Blower Motor Screw
d
b
a
End A
b
End B
c
Back of Microwave
a
Fan Blade Openings
b
Back of Microwave
b
13