Programing Your Timer - Orbit ST2-RF Manual Del Usuario

• Press the
ENTER button. The display now reads "SET
MONTH." Set the current month by pressing either the
or button.
• Press the
ENTER button. The display now reads "SET
DATE." Set the current day of the month by pressing either
the or button.
• Exit the set time and date mode at any time by turning the
selection dial.
Determine a Watering Plan
See page 0 for instructions.
Section 3: Programming Your Timer
Figure 2: Program A and Program B Dial Settings
Set Start Times
IMPORTANT: Multiple start times in Program A will repeat the water-
ing program. Generally, only one cycle start time is required for each
program (A and B) Start times do not correspond to individual stations.
6
07WTM002598 57926-24 rA.indd 6
• Turn the selection dial to
START TIMES
wish to set (A or B).
• Set Start Time 1 using the
and
• If you wish to set additional start times (up to six) for the same
program, press the NEXT
• To remove a start time press
CLEAR
• Exit the set start time mode by turning the selection dial.
Set Station Watering Durations
• Turn the selection dial to
DURATION
wish to set (A or B).
• Set the desired duration (0 - 10 minutes) for the station
displayed. Press NEXT or
the next station. Press CLEAR
IMPORTANT: Each station can have two durations. For example:
Station 1 can have a duration of 5 minutes in Program A and a
duration of 25 minutes in Program B. Typically a station has only
one duration in either Program A of B. A station with a setting of 0
minutes will not water with that Program.
• If two programs are needed repeat these steps for the other
program.
• Exit the set watering durations mode by turning the
selection dial.
for the program you
buttons.
button or ENTER button.
C .
for the program you
ENTER to advance to
to remove a duration.
C
2/16/07 2:07:20 PM