Orbit ST2-RF Manual Del Usuario página 9

says. (For example, in some water districts, watering is
prohibited on certain days.) To cancel programmed watering on
specific days of the week, follow these steps:
• Turn the selection dial to
the display, you will see the seven days of the week with a
water drop above each day. The water drop means watering
is allowed on that particular day.
• Press the
NEXT button to select the day of the week
you don't want to water. (The day will flash.)
• Press the
CLEAR C button. The water drop above that day
will disappear and the "ON" on the bottom right of the
display will change to "OFF ." This means the timer will pre-
vent watering on that day.
• To unblock a day that has been selected as a no watering day,
select the day (following the same steps), then press the
ENTER button. The water drop will reappear and the
"OFF" will change to "ON."
• Exit the "NO WATERING DAY" selection mode by turning
the selection dial.
To Prevent Watering During a
Particular Period of the Day:
There may be a time of the day when you never want the water
to come on, regardless of what the program calls for. (Perhaps
your community has banned watering during certain periods
of the day, or you don't want your children to get wet going to
school.) Here' s what to do:
8
07WTM002598 57926-24 rA.indd 8
NO WATERING DAY/PERIOD. On
• Turn the selection dial to
NO WATERING
• Press the
RAIN DELAY button. The display reads "SET NO
WATER START PERIOD."
• Press either the
or button to set the start time of the
period you don't want the water to come on.
• Press the
ENTER button. The display reads "SET NO
WATER END PERIOD."
• Press either the
or button to set the end time of the
period you don't want the water to come on.
• Exit the "NO WATERING PERIOD" selection mode by turn-
ing the selection dial.
NOTE: If programmed watering is interrupted by a no-watering
period, the timer will resume the watering schedule where it left off
as soon as the no-watering period is over. If the no-watering period
prevents scheduled watering from starting, the timer will start the
watering as soon as the no-watering period is over. This feature is
called "stacking."
Set Water Budgeting:
Water Budgeting is a quick way to adjust your set durations (10
to 00%) based on seasonal requirements.
• Turn the selection dial to BUDGETING/LANGUAGE.
• Either press the
button to increase the watering times, or
press the button to decrease the times in increments
of 10 percent. A setting of 100% will not change the set
durations, a setting of 00% will increase a 10 minute
DAY/PERIOD.
2/16/07 2:07:21 PM