Installation And Connection - Nice OXI Instrucciones Y Advertencias Para La Instalación Y El Uso

– This receiver automatically recognises the characteristics of the control unit on which it is installed and self-
sets in the following way:
- If the control unit manages the "BusT4", the receiver makes available up to 15 different commands.
- If the control unit DOES NOT manage the "BusT4", the receiver makes available up to 4 different commands.
Important! – In both cases, the number and diversity of the available commands depend on the type and
model of the control unit adopted. The "Table of commands" of each control unit is shown in the respective
instruction manual.
2

INSTALLATION AND CONNECTION

The receiver must be connected to the control unit by inserting it through the relevant slot:
01.
Before inserting (or removing) the receiver, discon-
nect the power supply to the control unit.
02. Connect the antenna supplied to terminal 1 of the re-
ceiver, as shown in Fig. A. Alternatively, if the radio
signal reception must be improved through the instal-
lation of an external antenna with a coaxial cable with
50Ω impedance (type RG58), the coaxial cable must
be connected directly to terminals 1 and 2 of the re-
ceiver (Fig. B), ignoring the "antenna" terminal (if pre-
sent) on the control panel.
OFF
Fig. A Fig. B
English - 2