Ordering Replacement Parts - HERKULES ZGS 3300 UG Manual De Instrucciones

Anleitung ZGS 3300 UG_SPK7:_
GB
Retighten the locking grip (10) in order to secure
the turntable in place.
Undo the locknut (13) and use the handle (2) to
tilt the machine head (4) to the left until it
coincides with the required angle value (in this
connection see also section 7.5).
Retighten the locknut (13). Cut as described
under section 7.4.
7.8 Changing the saw blade (Fig. 13)
Pull out the power plug.
Swing up the machine head (4).
Swing up the adjustable blade guard (6).
Press the saw shaft lock (17) with one hand while
holding the wrench (32) on the flange bolt (25)
with the other.
Firmly press on the saw shaft lock (17) and
slowly rotate the flange bolt (25) in clockwise
direction. The saw shaft lock engages after no
more than one rotation.
Now, using a little more force, slacken the flange
bolt (25) in clockwise direction.
Turn the flange bolt (25) until it is completely
removed.
Take the blade (5) off of the inner flange and pull
out.
Mount and fasten the new blade in reverse order.
Important! The cutting angle of the teeth (i.e. the
direction of rotation of the saw blade) must
coincide with the direction of the arrow on the
housing.
The blade flanges must be thoroughly cleaned
prior to mounting the blade.
Reattach the movable blade guard (6) in reverse
order.
Ensure that the saw shaft lock (17) is slackened.
Check to make sure that all safety devices are
properly mounted and in good working condition
before you begin working with the saw again.
Important: Every time that you change the saw
blade, check to see that it spins freely in the
groove of the turntable in both perpendicular and
45° angle settings.
7.9 Carrying the saw
Release the miter engagement button (10) and
turn the table all the way to the right. Lock the
table at a miter angle of 45°.
Pull the cutting head forward and lock the slide.
Lower the cutting head and press in the locking
button (16).
Carry the crosscut and miter box saw by its
integral carry-handle (31) and the side of the
base.
12
06.06.2007 14:52 Uhr Seite 12
8. Maintenance
Always keep the machineʼs ventilation slats clean
and free of obstructions.
Remove dust and dirt regularly from the machine.
Cleaning is best done with compressed air or a
rag.
Lubricate all moving parts at regular intervals.
Never use caustic agents to clean plastic parts.

9. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required replacement part
For our latest prices and information please go to
www.isc-gmbh.info