Replacing Wear Parts - Abicor Binzel ROBO Compact W600 Instructivo De Servicio

9 Maintenance and cleaning

9.3 Replacing wear parts

NOTICE
• Use only original ABICOR BINZEL wear parts.
• Use the ABICOR BINZEL switch key wrench to mount and disassemble the wear parts,
and make sure that the connections are properly assigned.
• Use the average tightening torque to tighten the wear parts.
 Tab. 12 Tightening torques for wear parts on page EN-20
• Replace any damaged, deformed or worn parts.
• Spray the wear parts with ABICOR BINZEL anti-spatter fluid.
• Test the TCP in the alignment jig after every use or following a collision.
Replace wear parts in accordance with the figures below:
Disassembly A: (1), (2), (3), (4)
Mounting direction B: (4), (3), (2), (1)
1
1 Gas nozzle
Fig. 7 Replacing wear parts
Name
Tip adaptor M8/M16×1 19.5 mm
Contact tip M8/30
Tip adaptor M12/M16×1 23.0 mm
Contact tip M12/45
Tab. 12 Tightening torques for wear parts
EN - 20
2
2 Contact tip
M
7
7
7
10
3
3 Tip adaptor
[Nm] M
min average
8.5
8.5
11
12.5
ROBO Compact W600
4
4 Gas diffuser
[Nm] M [Nm]
max
10
10
15
15
BAL.0374.0 • 2019-04-01