Risk Of Burns; Replacing The Torch Neck - Abicor Binzel ABIMIG A Instructivo De Servicio

9 Disposal
DANGER

Risk of burns

Risk of burns from hot coolant and hot surfaces.
• Switch off the coolant recirculator before starting maintenance, servicing, assembly,
disassembly or repair work.
• Allow the welding torches to cool down.
• Wear the correct protective gloves.
NOTICE
• The specified maintenance intervals are guidance values and refer to single-shift
operation.
• Maintenance and cleaning work may only be carried out by qualified personnel (in
Germany see TRBS 1203).
• Check the coolant hoses, seals and connectors for damage or leaks and replace if
necessary.
• Check and clean the power contact surfaces on the torch neck and torch neck seat.
• Always wear your personal protective equipment when performing maintenance and
cleaning work.
• Remove any adhering weld spatter.
• Ensure that all threaded fittings are tight.

8.1 Replacing the torch neck

 5.1 Setting up the torch on page EN-7
9 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
EN - 18
ABIMIG
BAL.0402.0 • 2018-08-24
®