CAMPAGNOLO ERGOPOWER Manual De Usuario página 17

• Attach the casing to the Ergopower as
illustrated (Fig. 4 and Fig. 5): the rear
derailleur (or front derailleur) casing
(A - Fig. 4) should be positioned in the
outer slot of the control unit; the brake
casing (B - Fig. 4) should be positioned in
the inner slot of the Ergopower unit.
If you prefer, you can pass the derailleur
cable casing alongside the brake casing,
as shown in figure 5.
30
4
A
B
5
B
A
ENGLISH
Rear derailleur cable and casing.
• Fit the end of the casing (680 mm long -
diameter ø 4.5 mm) with the casing end
already fitted in the external slot of the
RH Ergopower control unit.
• Set the control in the smallest sprocket
position by pressing lever (A - Fig. 6)
repeatedly and fit the rear derailleur
cable (2,000 mm - diameter ø 1.2 mm)
in the appropriate hole (B - Fig. 7).
• Cut the casing so that it reaches the
dial coupling on the frame (C - Fig. 8). Be
sure to leave enough slack in the casing
to allow ful handlebar movement. Attach
an end cap on the cut end of the casing
and attach the cable and the casing to
the casing retainer clamp.
ENGLISH
6
A
7
B
8
C
31