Installation - CAMPAGNOLO ERGOPOWER Manual De Usuario

3. INSTALLATION

• Raise the support cover (A - Fig. 1) to expose the securing screw (B - Fig. 1).
• Loosen the Allen securing screw by 5 mm (B - Fig. 1) located on the upper part of the
body, so that the retaining band can be slid over the non-taped handlebar without remov-
ing the band from the Ergopower unit. Make sure that the arrow on the band faces
towards the upper part of the control unit (C - Fig. 2).
• If the support cover has been completely removed, moisten the inside slightly with alco-
hol to facilitate installation on the control unit.
1
Min. ø 23.8 mm
Max. ø 24.2 mm
24
2
C
A
B
10 N.m - 7.4 lb.ft
ENGLISH
• For the majority of handlebars, the optimal position for the control unit is obtained by
aligning the lower end of the brake lever with the lower end of the handlebar (Fig. 3); it
should also be correctly oriented to avoid affecting bicycle aerodynamics (Fig. 4).
Note.
The gap between the control lever and the handlebars must ensure suitable grip as the
same time as sufficient lever movement for correct braking power.
• Secure the control on to the handlebar by tightening the 5 mm Allen screw (B - Fig. 1 -
Page 6) to 10 N.m using a torque wrench.
• Fit the casing retainer clamps on the frame dial mountings (Fig. 5).
Note.
Carbon frames require specific casing retainer clamps:
- in aluminum: code EC-RE002
- in plastic: code EC-AT002
3
5
ENGLISH
4
NO!
OK!
NO!
25