Settings; Changing Tools; Fitting The Splinterguard; Fitting The Chip Guard - Festool TRION PS 300 Q Manual De Instrucciones

TRION
GB
WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of maintenance on the
machine!
Connecting and detaching the mains power cable
[1-3] see Fig. [2a].
PS 300 Q, PS 300 EQ
The power tool has a slide switch to switch the tool
on and off (I = ON, 0 = OFF).
PSB 300 Q, PSB 300 EQ
The power tool have a push button switch [2-2] to
switch the tool on and off.
The locking button [2-1] can be engaged to operate
in continuous mode. Press the switch again to re-
lease the knob.
7

Settings

WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of maintenance on the
machine!
7.1

Changing tools

CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-

tive.
Wear protective gloves.

Open chuck lever [3-4] up to the stop.

Remove fitted saw blade.

Insert new saw blade up to the stop in the saw

blade holder [3-1].
Close chuck lever.

7.2 Adjusting three saw blade guide
The pendulum jigsaws have an additional hard
metal guide [3-2] immediately above the workpiece
for a better guidance of the saw blade.
Tighten the screw [3-3] with the Allen keyl [1-4]

until the jaws almost rest against the saw blade.
14
The saw blade should still be able to be
moved easily!
7.3

Fitting the splinterguard

The splinterguard allows cuts with splinter-free
edges, even on the exit side of the saw blade.
With the tool switched off, fit the splinterguard

[4-3] on the guide [4-2] up to the saw blade,
switch the jigsaw on,

with the tool running, push the splinterguard in

until the splinterguard is flush with the front
edge of the base runner. Thereby the splinter-
guard is cut in.
 The splinterguard must lie close to the saw
blade on both sides to ensure its reliable opera-
tion. Thus, a new splinterguard should be fitted
every time the saw blade is changed to ensure
splinter-free cuts.
7.4

Fitting the chip guard

The chip guard prevents chips from flying off and
improves the efficiency of the chip extractor.
Insert the chip guard [2-8] between the base

runner and chuck lever,
push back the chip guard with a slight pressure

until it catches in place.
7.5

Dust extraction

WARNING
Dust hazard
Dust can be hazardous to health. Always work

with a dust extractor.
Always read applicable national regulations be-

fore extracting hazardous dust.
Jigsaws can be connected to a dust extractor (hose
diameter 27 mm) using the extractor adapter [2-4].
 When working with suction units, always use a
splinterguard in order to prevent the suction
channels becoming blocked.
Insert the extractor adapter into the rear hole of

the base runner in so that the hook [2-6] catch-
es in the notch [2-7].
Press the lever [2-5] to remove the extractor

adapter.
7.6

Adjusting the base runner

The base runner can be swivelled to both sides by
up to 45° for bevel cuts.
Remove chip guard and splinterguard,

release locking screw [4-1] with Allen key [1-

4],