Proper Preparation Of The Working Area; Electromagnetic Compatibility; Laser Classification For Class 2 Laser Products - Hilti PM 30-MG Manual De Instrucciones Original

2.2

Proper preparation of the working area

▶ Avoid awkward body positions when working from ladders. Make sure you work from a safe stance and
stay in balance at all times.
▶ Secure the site in which you are taking measurements and take care to avoid directing the beam towards
other persons or towards yourself when setting up the tool.
▶ Measurements taken through panes of glass or other objects may be inaccurate.
▶ Ensure that the tool is set up on a stable, level surface (not subject to vibration).
▶ Use the tool only within its specified limits.
▶ If several laser tools are used in the same working area, care must be taken to avoid confusing the
beams.
▶ Strong magnetic fields may affect the accuracy of the tool. Magnetic objects should thus be kept away
from the measuring tool. Hilti magnetic adapters may be used.
▶ When the tool is brought into a warm environment from very cold conditions, or vice-versa, allow it to
become acclimatized before use.
2.3

Electromagnetic compatibility

Although the device complies with the strict requirements of the applicable directives, Hilti cannot entirely
rule out the possibility of interference to the device caused by powerful electromagnetic radiation, possibly
leading to incorrect operation. Check the accuracy of the device by taking measurements by other means
when working under such conditions, or if you are unsure. Likewise, Hilti cannot rule out the possibility of
interference with other devices (e.g. aircraft navigation equipment).
2.4

Laser classification for Class 2 laser products

The tool complies with Laser Class 2 in accordance with IEC / EN 60825-1: 2014 and in accordance with CFR
21 Sec. 1040 (FDA). These devices can be used without further protective measures. Nevertheless, as with
the sun, do not look directly into the light source. If you do inadvertently look into the laser beam, immediately
close your eyes and move your head clear of the laser beam. Do not aim the laser beam at persons.
2.5 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
*2243556*
Printed: 08.05.2019 | Doc-Nr: PUB / 5492771 / 000 / 00
2243556 English 13