Connection Diagram For The Emergency-Current Siren Wiring Harness; Connection Diagram For The Tilt Sensor Wiring Harness (Optional) - BMW DWA V Instrucciones De Montaje

4. Connection diagram for the emergency-current siren wiring harness

F 36 82 916 R
Item Description
S White 8-pin plug
SC Black 6-pin plug
SN Branch for emergency lock
SM Bonnet contact switch
branch
S3 Siren acoustics branch
S4 Alarm branch
S6 Terminal 31 branch
S15 Terminal 30 branch
S19 Control cable branch
S24 Bonnet contact switch
branch

5. Connection diagram for the tilt sensor wiring harness (optional)

F 36 82 915 R
!
As a result of technical modifications, the tilt alarm sensor must not be connected as described in
installation instructions 01 29 9 789 088.
It must be ensured that branch b, cable colour black/red/yellow is connected to the 24-pin plug A on
the DWA wiring harness, pin 5.
Item Description
a White 6-pin plug
b Terminal 75 branch
(radio setting)
c Tilt alarm sensor terminal
31 branch when alarm is
triggered
d Terminal 30 branch
e Terminal 31 branch
Cable colour/
Signal
cross-section
––––– –––––
––––– –––––
––––– red/black
0.75 mm
Negative with black
bonnet open 0.75 mm
Positive violet/grey
0.75 mm
Positive white/black
when alarm 0.75 mm
is triggered
Negative brown
0.75 mm
Positive red
0.75 mm
Positive brown/red
when DWA is 0.75 mm
deactivated
Negative with black
bonnet open 0.75 mm
Connection
Cable colour
plug a
black/red/
5
yellow
black/white/
1
yellow
red/grey/
2
yellow
black
3
Connection location in the car
Emergency-current siren, in front right of the engine
compartment
Connect to plug C on the DWA wiring harness
Branch is not required, insulate cable and tie it back
2
In engine compartment, front right on bonnet
2 contact switch
Plug SC, pin 4
2
Plug SC, pin 3
2
Plug SC, pin 1
2
Plug SC, pin 6
2
Plug SC, pin 5
2
Connect branch A24 (cable colour brown/violet)
2 from the DWA wiring harness to branch S24 of
the emergency-current siren wiring harness
Connection location in the car
Connect to the tilt alarm sensor
To DWA wiring harness, white 24-pin plug A, pin 5
(cable colour violet/white)
Cut the cable from pin 5 at a suitable position and
connect branch b to it using AMP contacts
To DWA wiring harness, white 8-pin plug B, pin 2
To DWA wiring harness, white 8-pin plug B, pin 1
To DWA wiring harness, white 8-pin plug B, pin 3
25