Check Before Starting; Starting And Stopping - VITO AGRO Manual De Instrucciones

EN
IMPORTANT
Any failure in the correct mixture
can cause engine damage.
When preparing the mixture
fuel mixture only
the amount needed for
work to make .
Do not use fuel that is stored for
more than two months . Blended
fuel stored causes difficulty in
starting and a lower performance.
If the mixture is stored for a long
period should be removed and filling
with fresh mixture .

CHECK BEFORE STARTING

- Never use the machine without a
guard nor with a defective guard.
- All covers must be correctly fitted
and undamaged before you start the
machine.
- Check the blade to ensure that no
cracks have formed at the bottom of
the teeth or by the centre hole. The
most common reason why cracks
are formed is that sharp corners
have been formed at the bottom of
the teeth while sharpening or that
the blade has been used with dull
teeth. Discard a blade if cracks are
found.
- Check that the support flange is
not cracked due to fatigue or due to
being tightened too much. Discard
the support flange if it is cracked.
- Ensure the locking nut has not
lost its captive force. The nut lock
should have a locking force of at
least 1.5 Nm. The tightening torque
of the locking nut should be 35-50
Nm.
- Check that the blade guard is
not damaged or cracked. Replace
the blade guard if it is exposed to
impact or is cracked.
- Check that the trimmer head and
trimmer guard are not damaged or
cracked. Replace the trimmer head
or trimmer guard if they have been
exposed to impact or are cracked.

STARTING AND STOPPING

WARNING
The complete clutch cover and shaft
must be fitted before the machine is
started, otherwise the clutch can come
loose and cause personal injury.
Always move the machine away
from the refuelling area before
starting. Place the machine on a
flat surface. Ensure the cutting
attachment cannot come into
contact with any object.
Make sure no unauthorised persons
are in the working area, otherwise
there is a risk of serious personal
injury. The safety distance is 15
metres.
STARTING
Ignition: Press down the "I" side of
the engine switch.
Primer bulb: Press the air purge
repeatedly until fuel begins to fill
the bulb. The bulb need not be
completely filled.
47