Starting The Engine - VITO AGRO Manual De Instrucciones

EN
4. Be sure the cutting attachment
guard is firmly attached in place.
5. Always use the harness. Adjust
the strap for comfort before starting
the engine. The strap should be
adjusted so the left hand can
comfortably hold the handlebar grip
approximately waist high.

STARTING THE ENGINE

1. Keep bystanders and animals at
least 15 m away from the operating
point. If you are approached,
immediately stop the engine.
2. The product is equipped with
a centrifugal clutch mechanism,
so the cutting attachment begins
to rotate as soon as the engine is
started by putting the throttle into
the start position. When starting the
engine, place the product onto the
ground in a flat clear area and hold
it firmly in place so as to ensure
that neither the cutting part nor the
throttle come into contact with any
obstacle when the engine starts.
WARNING
Never place the throttle into
the high-speed position when
starting the engine.
40
3. After starting the engine, check
to make sure that the cutting at-
tachment stops rotating when the
throttle is moved fully back to its
original position. If it continues to
rotate even after the throttle has been
moved fully back, turn off the engine
and take the unit to your authorized
servicing dealer for repair.
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by
the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand. Place
your feet slightly apart (slightly
further apart than the width of your
shoulders) so that your weight is
distributed evenly across both legs,
and always be sure to maintain a
steady, even posture while working.
2. Keep cutting attachment below
waist level.
3. Maintain the speed of the engine at
the level required to perform cutting
work, and never raise the speed of
the engine above the level necessary.
4. If the unit starts to shake or vi-
brate, turn off the engine and check
the whole unit. Do not use it until the
trouble has been prop-erly corrected.
5. Keep all parts of your body away
from rotating cutting attachment
and hot surfaces.
6. Never touch the muffler, spark
plug, or other metallic parts of
the engine while the engine is in
operation or immediately after
shutting down the engine. Doing
so could result in serious burns or
electrical shock.
7. Never operate the pruner at an
angle greater than 60 in order to
reduce the risk of being struck by
falling objects during operation.
IF SOMEONE COMES
1. Guard against hazardous situa-
tions at all times. Warn adults to
keep pets and children away from
the area. Be careful if you are
approached. Injury may result from
flying debris.
2. If someone calls out or otherwise
interrupts you while working, al-
ways be sure to turn off the en-gine
before turning around.