General Rules; Sharpening Grass Cutters And Grass Blades; Assembling The Handlebar - VITO AGRO Manual De Instrucciones

EN
A trimmer head is intended for
trimming grass.

GENERAL RULES

Only use cutting attachments with
the guards we recommend! See the
chapter on Technical data.
Keep the teeth of the blade correctly
sharpened! Follow our instructions
and use the recommended file
gauge. An incorrectly sharpened or
damaged blade increases the risk of
accidents.
Check the cutting attachment for
damage or cracks. A damaged
cutting attachment should always be
replaced.
44
SHARPENING GRASS
CUTTERS AND GRASS
BLADES
See the cutting attachment packaging
for correct sharpening instructions.
Sharpen blades and cutters using a
single-cut flat file.
Sharpen all edges equally to maintain
the balance of the blade.
WARNING
Always discard a blade that is bent,
twisted, cracked, broken or damaged
in any other way. Never attempt to
straighten a twisted blade so that
it can be reused. Only use original
blades of the specified type.
TRIMMER HEAD
IMPORTANT!
Always ensure the trimmer cord is
wound tightly and evenly around the
drum, otherwise the machine will
generate harmful vibration.
- Only use the recommended
trimmer heads and trimmer cords.
These have been tested by the
manufacturer to suit a particular
engine size. This is especially
important when a fully automatic
trimmer head is used. Only use the
recommended cutting attachment.
See the chapter on Technical data.
- Smaller machines generally
require small trimmer heads
and vice versa. This is because
when clearing using a cord the
engine must throw out the cord
radially from the trimmer head and
overcome the resistance of the
grass being cleared.
- The length of the cord is also
important. A longer cord requires
greater engine power than a shorter
cord of the same diameter.
- Make sure that the cutter on the
trimmer guard is intact. This is used
to cut the cord to the correct length.
- To increase the life of the cord it
can be soaked in water for a couple
of days. This will make the line
tougher so that it lasts longer.
ASSEMBLING
THE HANDLEBAR
Lift the green cover (B) from the
handlebar bracket.
Fully loosen the screw (A) with the
provided Allen (Hexagonal) wrench.
Remove the upper handlebar
bracket (C).
Place the handlebar into the recess
on the lower handlebar bracket (E).
Insert part (C) into part (E).
Insert the screw (A) with the cap
(B) and tighten until it comes to
rest. Press the green part (B) down
to firmly fix the handlebar.