Air Filter - VITO AGRO Manual De Instrucciones

EN
GRASS TRIMMING WITH
A TRIMMER HEAD
TRIMMING
- Hold the trimmer head just above
the ground at an angle. It is the
end of the cord that does the work.
Let the cord work at its own pace.
Never press the cord into the area
to be cut.
- The cord can easily remove grass
and weeds up against walls, fences,
trees and borders, however it can
also damage sensitive bark on trees
and bushes, and damage fence posts.
- Reduce the risk of damaging plants
by shortening the cord to 10-12 cm
and reducing the engine speed.
CLEARING
- The clearing technique removes
all unwanted vegetation. Keep
the trimmer head just above the
ground and tilt it. Let the end of
the cord strike the ground around
trees, posts, statues and the like.
CAUTION! This technique increases
the wear on the cord.
- The cord wears quicker and must
be fed forward more often when
working against stones, brick,
concrete, metal fences, etc., than
when coming into contact with trees
and wooden fences.
- When trimming and clearing you
should use less than full throttle
so that the cord lasts longer and
to reduce the wear on the trimmer
head.
50
CUTTING
- The trimmer is ideal for cutting
grass that is difficult to reach using
a normal lawn mower. Keep the
cord parallel to the ground when
cutting. Avoid pressing the trimmer
head against the ground as this can
ruin the lawn and damage the tool.
- Do not allow the trimmer head to
constantly come into contact with
the ground during normal cutting.
Constant contact of this type can
cause damage and wear to the
trimmer head.
SWEEPING
- The fan effect of the rotating cord
can be used for quick and easy
clearing up. Hold the cord parallel
to and above the area to be swept
and move the tool to and fro.
- When cutting and sweeping you
should use full throttle to obtain the
best results.
CARBURETOR
ADJUSTING THE RALENTI
SPEED (T)
Check that the air filter is clean.
When the idle speed is correct,
the cutting attachment should not
rotate. If adjustment is required,
close (turn clockwise) the idle
adjustment screw T, with the
engine running, until the cutting
attachment starts to rotate. Open
(turn anticlockwise) the screw
until the cutting attachment stops.
The idle speed is correctly set
when the engine runs smoothly in
all positions, and there is a clear
margin to the speed at which the
cutting attachment starts to rotate
WARNING! If the idle speed
cannot be adjusted so that the
cutting attachment stops, contact
your dealer/service workshop. Do
not use the machine until it has
been correctly adjusted or repaired.
If you need to adjust the "L" and/or
"H" mixture screw contact with you
dealer/service center for some help.

AIR FILTER

The air filter must be regularly
cleaned to remove dust and dirt in
order to avoid:
- Carburetor malfunctions
- Starting problems
- Loss of engine power
- Unnecessary wear to engine parts.
- Excessive fuel consumption.
Clean the filter every 10 hours, or
more regularly if conditions are
exceptionally dusty.