Fitting Blades And Trimmer Heads; Fitting The Guard Extension; Fitting A Blade Guard, Grass Blade And Grass Cutter; Fitting The Trimmer Guard And Trimmer Head - VITO AGRO Manual De Instrucciones

EN
FITTING BLADES AND
TRIMMER HEADS
WARNING
When fitting the cutting attachment
it is extremely important that the
raised section on the top clamping
plate/support flange engages
correctly in the centre hole of the
cutting attachment. If the cutting
attachment is fitted incorrectly it
can result in serious and/or fatal
personal injury.
Never use a cutting attachment
without an approved guard. See
the chapter on Technical data. If an
incorrect or faulty guard is fitted this
can cause serious personal injury
IMPORTANT!
If a saw blade or grass blade are
to be used the machine must be
equipped with the correct handlebar,
blade guard and harness.
FITTING THE GUARD
EXTENSION
CAUTION! The guard extension
shall always be fitted when using the
trimmer head and combination guard.
The guard extension shall always be
removed when using the grass blade
and combination guard.
Hook the blade guard/combination
guard onto the fitting on the shaft
and secure with two bolts.
Enter the guard extension guide in the
slot of the combination guard. Then
click the guard extension into position
on the guard with some claws.
The guard extension is removed
easily using a screwdriver, see
illustration.
FITTING A BLADE GUARD,
GRASS BLADE AND GRASS
CUTTER
- Hook the blade guard/combination
guard onto the fitting on the shaft
and secure with two bolts. Use the
recommended blade guard. See the
Technical data section.
CAUTION! Ensure that the guard
extension is removed.
- Fit the top clamping plate (B) on the
output shaft.
- Turn the blade shaft until the hole in
the top clamping plate aligns with the
corresponding hole in the top protecting
cap.
- Insert the locking pin (A) in the hole to
lock the shaft.
- Place the blade (C), bottom clamping
plate (D) and bottom protecting cap (E)
on the output shaft.
- Fit the nut (F). The nut must be
tightened to a torque of 35-50 Nm
(3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner
as close to the blade guard as possible.
To tighten the nut, turn the spanner in
the opposite direction to the direction of
rotation (Caution! left-hand thread).
- Pull out the locking pin after all
installation process has been finished.
FITTING THE TRIMMER
GUARD AND TRIMMER
HEAD
- Fit the correct trimmer guard for use
with the trimmer head. CAUTION!
Ensure that the guard extension is fitted.
- Hook the trimmer guard/
combination guard onto the fitting on
the shaft and secure with two bolts.
45