Adjusting Granita Consistency; Dispensing Granita - horeca Granitore 1 Manual De Empleo

If the decimal point shown is on the left, the temperature refers to tank 1 (see
Fig.2 on Page 4).
Fig.18
If the decimal point shown is in the middle, the temperature refers to tank 2 (See
Fig.2 on Page 4).
Fig.19
If the decimal point shown is on the right, the temperature refers to tank 3 (See
Fig.2 on Page 4).
Fig.20
Note: If the temperature display should accidentally switch off
while the machine is being used, press the
up again. If the temperature display will not switch on again,
switch off the machine and contact the assistance centre.
Important: While using the machine, the temperature display
needs to be switched on at all times so as to see the tempera-
ture of the product in the tank.
SL310006542 Ed.02 - 07-2017

6.5. Adjusting granita consistency

The consistency of the granita may be adjusted (+/-) by means of the screw
The adjustment may be made by hand or with the aid of a suit-
able at-tip screwdriver.
Fig.21

6.6. Dispensing granita

To dispense the beverage, pull the tap lever.
Fig.22
Regularly check the temperature of the product in the bowl, us-
ing a standard thermometer, to make sure that the product is al-
ways below the storage temperature. Never disconnect the ma-
chine from the power supply or switch off the main switch when
there is any product still to be consumed inside the bowl.
. key to start it
If the machine is not used continuously, when used with milk-
based products, it is necessary to:
- spray sanitizer solution around the spigot area and on the
or:
- Dispense a small amount of the product from the spigot be-
+: thicker consistency, -: thinner consistency.
spigot itself (alternatively, wash with a clean cloth and sani-
tizer);
fore dispensing the serving for the customer.
- 11 _EN -