Conveyance And Handling; Storage; List Of Accessories Provided; Installation-Positioning - horeca Granitore 1 Manual De Empleo

4.2. Conveyance and handling

Make sure that no one is stationed within range of lifting and
handling operations. In dif cult conditions, specialized person-
nel should be appointed to oversee the movements of the ma-
chine.
Manual handling of the machine requires at least two people.
The machine must be moved into an upright position, only after every
bowl has been emptied of product.
Lift the box and carefully convey it, avoiding routes with obstacles. Pay attention
to the overall dimensions and any parts sticking out.
Warning: do not make any additional cuts on the packing con-
tainer.
The WARRANTY does not cover damage caused to the machine during its
conveyance and handling.
The Purchaser will bear the cost of repairing or replacing damaged parts

4.3. Storage

Before the machine is placed in storage and whenever the ma-
chine is started up again after a period of storage, it must be
thoroughly cleaned and sanitized.
Warning: do not store more than two machines stacked on top of one
another.
If the machine is to remain unused for a long period of time, due precautions
must be taken with respect to the place and duration of storage:
MAX
SL310006542 Ed.02 - 07-2017
5. INSTALLATION
currently in force.
The machine must be installed indoors in a well-lit and well-ventilated room with
The machine may only operate in places with an ambient temperature ranging
between 20°C and 32°C.

5.1. List of accessories provided

Vaseline: to lubricate all of the parts indicated in this manual after washing
and sanitization operations.

5.2. Installation-Positioning

The installer must check that:
within easy reach.
Figure 8 shows the minimum clearances for installation
Fig.8
Fig.7
All of the operations described in chapter 5 may be carried
out exclusively by specialized technicians, who must organ-
ize all the operational sequences and use suitable equip-
ment, in strict compliance with the applicable regulations
The machine is of the attended type, and must be installed in
places where it can be monitored by trained personnel.
Warning: it is forbidden to install the machine in a place where
it may be reached, touched and/or operated by persons other
than those speci ed in section 1.2.
Adequate clearance must be left around the machine to enable
personnel to work without any constraints and also to leave the
work area immediately in case of need.
25 cm
10 inches
150 cm
60 inches
- 7 _EN -