Electric Hookup - mabe ASCHAM09EYT Instructivo

drainage of the outdoor unit condensation water
Condensed water and the ice formed in the outdoor unit during
HEAT mode operation, can be drained through the drain pipe.
1. Fasten the drain port in the 25 mm hole located in the bottom of
the unit as shown in the figure.
2. Connect the drain port and the drain pipe. Make sure that water is drained to a proper place.

electric hookup

1. Remove the terminal block cover.
2. Connect the wires to the terminal block using the same numbers
as in the indoor unit.
3. Verify the connections using the wiring diagram placed on the
back of the cover.
4. Fasten the wires using the wire-clamps.
5. Make sure to connect the unit to a proper ground.
6. Replace the terminal block cover.
Outdoor unit
Drain pipe
Drain port
Electric wiring
diagram behind
the cover
Screw
Remove the
terminal block
cover
59