Operating The Unit; Operating The Nasal Washer. Optional; Changing The Air Filter; Unit Maintenance - Dr.Frei TURBO MINI Manual De Usuario

Operating the Unit

1. Put the device on a flat, stable surface.
2. Ensure that the rated voltage corresponds to the mains voltage supply.
3. Connect the device into the main socket.
4. Open the medicine cup unscrewing the two parts (A). Insert the pisper in the nozzle of medicine cup - underside
as illustrated in Figure (F).
5. Fill in the lower part of the medicine cup with the pharmaceutical (B). Note: The notches on the lower part of
medicine cup are only indicative.
6. Close the medicine cup screwing back on the two parts.
7. Connect the air cable (9) to the medicine cup (C).
8. Connect the air cable (9) to the air exit of the appliance.
9. Insert on the medicine cup the needed accessory: mask, mouthpiece or nosepiece (D).
10. Turn on the device moving the switch to ON position.
11. For treatment of upper airways, twist medicine cup to MAX (II), for treatment of lower airways, turn to MIN (I).
See picture (E).
12. After the application, turn off the device and unplug. Before restarting the appliance make sure it has
cooled to room temperature environment.
WARNING FOR A GOOD APPLICATION OF THE THERAPY:
• Sit down in a comfortable and upright position.
• If a mask (adult or children) is used, be sure that it adheres to the face. Mask has holes for the air
flow during the expiration phase. Breathe easy and have a short pause at the end of each breathe.
• If the mouthpiece is used, keep it lightly among the teeth with tight-lipped. Respiration must be
done through the mouth.
• If the nosepiece is used, put it softly on the nostrils. Don't insert it in the nose. Respiration must be
done through the nose.
• Therapeutic application ends when the medicine came out in a discontinuous mode (spluttering).

Operating the Nasal Washer. Optional

It can be bought as a spare part to this compressor nebulizer.
The nasal washer is intended for cleaning of a cavity of a nose and treatment of cold and chronic rhinitis.
To use the nasal washer, follow the instructions below:
1. Unscrew the top part (a).
2. Fill in the medicine tank (b).
3. Insert the pisper (c).
4. Close the nasal washer screwing back the two parts.
5. Connect the tube to the air inlet (d).
6. Put the nasal washer near the nostrils. Don't insert it in the nose.
7. After the therapy, clean carefully the nasal washer.
ATTENTION:
Do not inhale horizontally. Do not tilt the medicine cup over 45°.
Keep the accessories well ventilated, protected from heat and direct sunlight (D).

Changing the Air Filter

The filter has to be substituted after 30 hours of use or when it becomes grey. Filter replacement parts (H). For filter
replacing, raise the lid using a flat screwdriver as shown in the picture I. Remove the filter and fit a new filter (10). Fit
the filter carrier lid into its housing making sure it is adherent to the surface.

Cleaning the Unit

After each therapy remove the device from the socket and clean the device and the accessories. Attention: use only the accessories supplied with the product,
other accessories can lead to ineffective therapy.
CLEANING OF THE MOUTHPIECE AND NOSEPIECE
Use drinking water to carefully clean these accessories, when used. They can be sterilized by boiling for 5-10 minutes into the water or by immersion in a
chemical disinfectant (oxidizing electrolytic chloride), following product instructions and rinsing off with drinking water. Leave to dry naturally.
CLEANING OF THE MEDICINE CUP
EN
A
A
C C
E
E
a
c
I

UNIT MAINTENANCE

B
B
D D
F
F
b
d
H
5