Installation - Rena Ware UCU-500 EXTREME Uso Y Mantenimiento

INSTALLATION

WARNING: Read all the instructions completely before proceeding. If you are
uncertain about installing this product, we recommend you consult a professional.
This product should be installed in accordance with all local and state plumbing and
building codes.
TOOLS RECOMMENDED: PTFE plumber's tape or thread sealant, slotted
screwdriver, pliers, adjustable wrench, flashlight, and cloth. Your installation may
require new supply lines and/or shut-off valves or other additional tools.
LOCATE HOT WATER LINE: If you don't know which one is your HOT water line,
open the hot water tap. Wait 30 seconds and feel the two water feed lines under the
sink. The one that is warm is your HOT water feed line, the other is your cold water
feed line. Make a note of which is HOT and which is COLD. Also make note which
side each connects to the underside of the existing faucet because the COLD water
line will be disconnected later in the installation.
SHUT OFF WATER SUPPLY BEFORE INSTALLING: After locating the water
supply inlets, shut off the water supply valves. These are usually found under the sink
or near the water meter. If you are replacing an existing side faucet, remove the faucet
from the sink and clean the sink surface thoroughly.
24