Installation - Rena Ware UCU-500 EXTREME Uso Y Mantenimiento

INSTALLATION

WARNING: Read all the instructions completely before proceeding. Rena Ware
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
NOTE: If you have the single source faucet (cold only), your faucet has only one
supply tube and your sink will have only one supply line. Whenever these directions
refer to hot and cold supply tubes or supply lines, you will have only a single tube or
line to work with.
TOOLS RECOMMENDED: PTFE plumber's tape or thread sealant (use only on
threaded connections), plumber's putty, slotted screwdriver, pliers, adjustable wrench,
flashlight, and cloth. Your installation may require new supply lines and/or shut-off
valves or other additional tools.
SHUT OFF WATER SUPPLY BEFORE INSTALLING: Locate water supply inlets
and shut off the water supply valves. These are usually found under the sink or near
the water meter. If you are replacing an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
10