Intended Use - Wesco WS2550K Manual Del Usuario

Wear protective gloves
Screwdriving
Drilling
Wood
Metal
For indoor use only(for charger)
Double insulation(for charger)
Read the operator's manual.
The output plug is with positive
center pole and negative outer pole
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

Intended Use

The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE OPERATION
1.Charging the battery (See Fig. A)
The battery charger supplied is only for the Li-ion battery
installed in the tool. Do not use another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the tool is switched off by
means of a protective circuit: The tool will not turn on
when the trigger is engaged. When the Battery is charged
for the first time or after prolonged storage, the Battery
Pack will accept a 100% charge only after several charge
and discharge cycles.
EN
Plug the charger plug into a suitable power outlet. Next,
connect the charger to the Charging Socket on the tool.
The battery capacity indicator will on. Let the battery
charge for 5 hours. The battery capacity indicator
shows fully charged status with only green light on.After
the battery is fully charged, then unplug the charger.
Disconnect the Charger from the tool. The tool is ready
to be used.
Important: When charging, the charger and tool may
become warm to the touch, this is normal and does not
indicate a problem.
2.Indicator (battery capacity)
Light
Red on
Red on +yellow on
Red on +yellow on +
green on
Green on
Red flash
Note: The light will be activated when the
On/Off switch is slightly depressed, and will
automatically turn off 5 seconds after the
On/Off switch is released.
Note:If the battery pack is too hot, allow
battery pack to cool first to ambient
temperature and then recharging can be
started.
ASSEMBLY
1.Chuck adjustment and removing and
inserting the bits
Warning: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Make sure the forward/reverse rotation
control is in lock off position. Always ensure the bit is
secure before starting the tool. Damage to the Chuck or a
loose bit may cause possible personal injury.
Removing the bits(See Fig. B1)
Rotate the keyless chuck anti-clockwise, and remove
the bits.
Inserting the bits(See Fig. B2)
Rotate the keyless chuck clockwise, and insert the bits.
Status
0-33%
33%-66%
66%-100%
Fully charged
Battery temperature
protection
The temperature of battery
o
pack is less than 0 C or
o
more than 50 C.
17