Intended Use - Wesco WS2547 Manual Del Usuario

obtained if the battery pack is charged when the
air temperature is between 18
charge the battery pack in air temperatures below
o
4.5 C, or above 40.5
prevent serious damage to the battery pack.
SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries. Return exhausted
batteries to your local collection or recycling
point.
Warning
Do not burn
Do not expose to rain or water
For indoor use only( for charger).
Read the operator's manual.
T2A
Fuse
Positive terminal
Negative terminal
Double insulation (only for charger)
16
o o
C and 24 C. Do not
o
C. This is important as it can
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

Intended Use

The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
1. RECHARGING BATTERIES
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery to
cool down before recharging.
WARNING: Do not continue to press
the On/Off switch after the tool has
been automatically switched off. The
battery can be damaged.
B) IMPORTANT NOTES FOR CHARGING
THE BATTERY
The battery in your new tool is not charged when it leaves
the plant. Therefore it must be full charged before using
the first time
NOTE: If the battery pack is very hot you must remove
your battery pack from the charger and allow your battery
pack to cool first to ambient temperature and then
recharging can be started.
To prevent damage to the Battery Pack, when charge
runs out, please charge the battery to reach full or no less
than half charge before storage.
If the tool will not be used for long periods of
time, charge the battery every 3-6 months
C) CHARGING (See Fig. A)
1) Plug the charger into an appropriate outlet. The light
(a) will be green.
2) Insert the Battery Pack (4) into the charger, the light
(b) will be red to indicate the charging process has
started.
3) On completion of charge, the light (a) is green, and
light (b) will be off. The pack is now fully charged,
unplug the charger and remove the battery pack.
EN