Tabla de contenido
Idiomas disponibles
Idiomas disponibles
a) Never operate at higher speed than
the maximum speed rating of the drill
bit. At higher speeds, the bit is likely to
bend if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
b) Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
c) Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing
breakage or loss of control, resulting in
personal injury.
SCREWDRIVER AND
IMPACT WRENCH
SAFETY WARNING
1. Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring. Fasteners contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
SAFETY WARNINGS
FOR BATTERY CELLS
INSIDE THE TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal.
Do not store power tool haphazardly in a
box or drawer where charging terminal
may short-circuit each other or be
short-circuited by conductive materials.
When power tool is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can
make a connection from one charging terminal to
another.
c) Do not expose power tool to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject power tool to mechanical
EN
shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has
been made, wash the affected area with
copious amounts of water and seek
medical advice.
f)
Seek medical advice immediately if a
cell has been swallowed.
g) Keep power tool clean and dry.
h) Wipe the charging terminals with a
clean dry cloth if they become dirty.
i)
Power tool needs to be charged before
use. Always refer to this instruction and
use the correct charging procedure.
j)
Do not maintain power tool on charge
when not in use.
k) After extended periods of storage,
it may be necessary to charge and
discharge the power tool several times
to obtain maximum performance.
l)
Battery gives its best performance
when it is operated at normal room
temperature (20 °C ± 5 °C).
m) When disposing of cells, keep cells
of different electrochemical systems
separate from each other.
n) Recharge only with the charger
specified by WESCO. Do not use any
charger other than that specifically
provided for use with the equipment. A
charger that is suitable for one type of battery may
create a risk of fire when used with another battery.
o) Keep power tool out of the reach of
children.
p) Retain the original product literature for
future reference.
q) Dispose of properly.
r)
Do not mix cells of different
manufacture, capacity, size or type
within a device.
s) Do not use any cell which is not
designed for use with the equipment.
GENERAL SAFETY
WARNINGS
WARNING Read all safety warnings
and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire
15
Tabla de contenido
