AVM FRITZ! 1200 Guía De Instalación Y Operación página 6

2
Starting the Confi guration Wizard
1. Open the web browser on your computer and enter
http://fritz.repeater in the address bar.
2. The confi guration wizard appears and guides you through setup of the
wireless connection between the FRITZ!Repeater and your wireless
router.
3. Insert the FRITZ!Repeater into an outlet located about halfway
between the wireless router and the wireless devices to be added to
the wireless network. The FRITZ!Repeater and your wireless router
connect once more.
LED lights up green: the FRITZ!Repeater has a good wireless
connection and is ready for operation.
LED lights up orange: the FRITZ!Repeater has a weak wireless LAN
connection. Insert the the FRITZ!Repeater into an outlet closer to the
wireless router.
LED fl ashing orange: cannot connect via wireless LAN. Insert the the
FRITZ!Repeater into an outlet closer to the wireless router.
10
LAN Bridge: Connect the FRITZ!Repeater 1200 to the
Internet Router Using a LAN Cable
If you would like to connect the FRITZ!Repeater with your FRITZ!Box
(router) by cable, confi gure "LAN bridge" access mode in the user
interface of the FRITZ!Repeater.
Confi gure LAN Bridge
1. Connect the FRITZ!Repeater with your computer using a LAN cable
2. Insert the the FRITZ!Repeater into an electrical outlet.
3. Wait about 1 minute until the FRITZ!Repeater starts.
4. Open a web browser on the computer and enter http://fritz.repeater.
The user interface of the FRITZ!Repeater appears.
5. Assign a password for the user interface and click "OK".
6. Enter the password again and click "Log In" and "Next".
7. Enable the "LAN bridge" access mode and click "Next".
8. Follow the wizard's further instructions.
9. After the fi nal confi guration step, disconnect the LAN cable from the
computer and connect the FRITZ!Repeater with your FRITZ!Box (router).
11