Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Turn the unit on by briefly pressing the
(10)
will light up. The display shows the battery
IR Illuminator switches automatically to position
To turn the display off during operation, press and hold down the ON
(4) button for more than one second.
The display will show a
DISPLAY OFF
To turn the display on, press
second.
To turn the unit off, press and hold down the
three second. The display shows message
countdown will start from 3 to seconds, and the unit turns off.
Achieve a crisp image of the icons on the display by rotating the
eyepiece diopter adjustment ring
Locate an object within 20 to 30 metres.
Achive a crisp image of the object by rotating the objective lens
Adjust the image brightness by turning the adjustment wheel
brightness level and brightness icon
corner of the display. The adjustment range is 0 to 20.
When changing the viewing distance, obtain a sharp and high-
quality image by rotating the objective lens
There is no need to rotate the eyepiece - you have already made the
necessary individual adjustment.
To increase the range of detection and identification in low light
conditions or in complete darkness, you may switch on the built-in
LED IR Illuminator
(9)
by pressing the
illuminator allows you to increase the observation distance and
recognise the object.
Press the
IR
button successively to change power level (from 1 to 3).
The corresponding icon
display.
To turn the IR Illuminator off, press and hold down the
two seconds. The IR icon will disappear.
You can find a detailed description of IR Illuminator operation in
section
12 "BUILT-IN IR ILLUMINATOR"
To activate the digital zoom, briefly press the
6
5
ON (4)
button - the
green LED
charge
icon
message.
br
iefly the
ON
button for more than one
ON
button for more than
"Switch off"
1
(2)
.
(8)
are shown in the right top
(1)
and the wheel
IR (5)
button. The IR
will appear in the upper part of the
IR
button for
.
ZOOM (7)
button.
9
.
The
OPERATING MODES
The operating modes are as follows:
Video (video recording)
Photo (image capture)
R
eview
When first switched on, the unit is in Video mode. Switch between
operating modes by a long press of the REC (6) button. This enables you
to cycle between modes (Video->Photo->Review->Video...)
,
VIDEO MODE
Video recording mode is the default mode.
Video recording mode is shown by the
Sound recording is shown by the
Full magnification is shown with by special icon (i.e. 13x) on the
display.
(1)
.
. The
(8)
.
To start or stop video recording, briefly press the REC (6) button.
Video clips are saved in the internal Flash memory when video recording
is stopped or the unit is turned off.
Video recording indication on the display:
The REC (6) icon appears in place of the "VIDEO" icon.
Display icons are not recorded.
You can enter and navigate the menu during video recording.
Note! You can stop recording video only after exiting the menu.
Video recording
(video and image review)
icon on the display.
VIDEO mode
ZOOM
SOUND
13x
01:42
04:23pm
Record timer
ZOOM
SOUND
13x
REC
00:42
00:02
icon on the display.
Current time
Elapsed recording time
6
Tabla de contenido
