Description Of Components - Urmet 1722/58A Manual De Instalación

7. Power on the device.
8. Complete your parameter confi guration by
using the Urmet CallMe App.
The Urmet CallMe App confi guration
manual is available on the www.urmet.
com website or by scanning the QR
code at the end of the section.
9. Install the cover.
If, at a later stage, it becomes necessary
to remove the cover use a screwdriver in
the indicated points.
2
DS1722-111
1
2
1
1.3. DESCRIPTION OF
COMPONENTS
1 2 5 3
1. STATUS LED: LED showing the state of your
Internet connection.
• fl ashing red light: the device is turned on in
the confi guration mode;
• steady green light: the device has been
correctly registered with the Urmet SIP
server and is ready to forward calls to a
smartphone;
• steady red light: the device is showing that
there is no Internet connection;
• steady orange light: device not enabled (no
active Wi-Fi.)
During power-on or after pressing
the PROGR/RESET key, the device
will need 50s to start up; during this
time, the LED will remain off.
2. PROGR/RESET key: by pressing the button
for a time
• comprised between 2s and 4s, the device
will restart in the confi guration mode
(maintaining any parameters that had already
been confi gured);
• shorter than 2s or longer than 4s, the
device will be restarted.
• after 5 short consecutive presses (at time
intervals shorter than 1s) the device will
restore its factory parameters and signal
the event with a fl ashing red/orange/green
LED light, to then switch to the confi guration
mode.
3. LAN connector: Ethernet port for wired
connection to the home network.
4 6 7 8
11