Description Of Terminals And Connectors; Technical Specifications; Installation - Urmet BiBus sinthesi s2 Manual De Instrucciones

10
11
L2 L1 GND PA SP
MP2
CONTR.
12
13
10. Not.used.
11. Extractable. connection. terminal. boards. (MP,.
MV1,.MS1).
12 Adjustable LCD contrast.
13. Extractable.connection.terminal.board.(MP1).
DESCRIPTION OF TERMINALS AND
CONNECTORS
MP1 terminal board
~0 Power 12Vac
~12 Power 12Vac
+T Back-up power positive
GND Back-up power negative
SE1.. Electrical.lock.connection.
SE.. Electrical.lock.connection.
DS107-035
SN R R1 H P GND
MV1 MS1
Sch./Ref. 1072/17
Data:....................
~0
~12
+T
GND
SE1
SE2
MP1
MP2 terminal board
L1 Bus line 1st wire
L2 Bus line 2nd wire
GND.. Reference.electrical.earth.
PA.. Hall.door.opener.button.input.
SP.. Open.door.sensor.contact.input.
MV1 terminal board
SN Video power unit on signal for video systems
+EP DT
R Video switching enable signal for video systems
R1 Video power earth
MS1 terminal board
H.. Door.opener.code.time.band.contact.input.
P.. Mail.key.input.
GND.. Reference.electrical.earth.
+EP Auxiliary device power
DT.. Not.used.
CNA.. Not.used
CNP.. Programming.keyboard.connector.103/65
CNS.. PC.serial.line.connector.

TECHNICAL SPECIFICATIONS

Power:
Stand-by.consumption:...
Maximum.consumption:..
R.signal:..
Lock.hold.current:..
Working.temperature.range:.. - 10.+50°C
Humidity:..

INSTALLATION

Refer. to. the. "technical. manual". for. instructions. for.
installing.the.call.module..The.module.is.programmed.
by default with a jumper between the earth and the
"SP". signal. to. simulate. the. door. closed. contact..
Remove the jumper and connect the sensor between
GND and SP when the open door contact is required.
Connect.the.electrical.lock.positive.to.terminal.SE1.
and the negative to terminal SE2 when polarised
electrical.locks.are.used..
12Vac nominal
300mAac.max.
600mAac.max..
. Imax.=.80mA
. 190mA.max.
. 90%[email protected]°C
19