Operating Instructions; Starting Up; Switching On The Power; Program Selection - Primus I35/50 Manual De Uso

4. OPERATING INSTRUCTIONS

4.1. STARTING UP

Before the machine is started up for the first time, make sure that the machine is installed properly – see
„Installation and maintenance manual". Check the condition of dust filter and other parts of the machine
according to „Installation and maintenance manual".

4.2. SWITCHING ON THE POWER

Turn the main switch on the rear part of the ironer left stand to the position marked „I" – display will light up.

4.3. PROGRAM SELECTION

Version OPL: press the button „SELECT" for the program selection. Then you can increase the program
number by the button „SELECT" or „+" and decrease by „-" on the upper display. Selected program will be
read from the memory 2s after the last press of any of mentioned buttons (this avoids e.g. sudden changes
of the speed when selecting program during the machine operation).
Version with coin meter: program selection is not available, the machine operates with one program only.
Choose operation temperature according to the type of linen – see following table:
TEMPERATURE (°C)
85
110
135
170
170
175

4.4. START OF IRONING

Version OPL: press the button „START" – the machine is started, it means start of the roller drive,
ventilator(s), heating and clutch of the feeding belts drive (when the machine is equipped with the clutch).
Version with coin meter: insert necessary coins into the coin meter (at the same time the charged time of
ironing in minutes is displayed) and press the button „START" – start of the roller drive, ventilator(s) and
heating, but not the clutch of the feeding belts drive.

4.5. PROCESS OF HEATING

After the machine is started, it is necessary to wait for heating of ironing roller to needy temperature. At the same
time, underpressure switches are checked before start of heating.
Version OPL: heating process is possible to watch on the lower display after pressing the button for temperature.
Version with coin meter: end of heating process is signalized by discontinuous sound of buzzer. At that moment
the charged time starts to decrease.
WARNING: if the customer tries to iron before end of heating (by inserting the linen under the finger guard),
the charged time starts to decrease immediately and the buzzer sounds.

4.6. IRONING

Version OPL: ironing can be started as soon as the actual temperature reaches the value close to required
value for particular type of linen. Check, if the cloth can be ironed and at which temperature.It is possible to
modify the temperature value and speed value during the ironing process – see: „Programming manual".
Version with coin meter: ironing is possible to start as soon as the buzzer sounds – start the feeding belts
by pressing the pedal. During ironing it is possible to extend the time of ironing by inserting another coins.
One minute before time runs out, the buzzer is started (for 10 sec) to inform an operator about oncoming end
of paid time.
10
MATERIAL
Polyacryl, Polyamid
Polyester, Cellulose
Silk
Wool
Cotton
Flax
USER´S MANUAL
You can stop and start feeding belts (fig. 4.6.A, pos. 3)
by treading the pedal (2) for correct feeding of linen.
If you feed the linen incorrectly, use the backstroke
for its releasing.
THIS OPERATION CAN BE EXECUTED ONLY
FOR TIME NECESSARY FOR TAKING THE
LINEN OUT.
Fig. 4.6.A
PUBLICATION DATE 10/03 508 816