Electrical Connection - Gaggenau AW 250 Instrucciones De Montaje

An air-intake/exhaust-ir wall box by itself is no
guarantee that the limiting value will not be
exceeded .
Note: when assessing the overall requirement, the
combined ventilation system for the entire house-
hold must be taken into consideration. This rule
does not apply to the use of cooking appliances,
such as hobs and ovens.
If the exhaust air is going to be discharged into
the open, a telescopic wall box should be fitted
into the outside wall.
For optimum extractor hood efficiency:
•
Short, smooth air exhaust pipe.
•
As few bends in the pipes as possible
•
Diameter of pipe to be as large as possible
and no tight bends in pipe.
•
If long rough exhaust-air pipes, many pipe
bends or smaller pipe diameters are used,
the air extraction rate will no longer be at
an optimum level and there will be an
increase in noise.
•
Round pipes:
we recommend
Internal diameter: 150 mm, at least 120 mm.
•
Flat duct must have an internal cross section
that equates to that of round pipes
There should be no sharp bends.
Ø 120 mm ca. 113cm
Ø 150 mm ca. 177cm
• If pipes have different diameters:
insert sealing strips.
•
For exhaust air mode, ensure that there is
an adequate supply of fresh air.
Connecting a Ø 150 mm exhaust air pipe:
•
Mount the pipe directly onto the air outlet on
the hood.
Connecting a Ø 120 mm exhaust air pipe:
•
Place the reducing connecting piece onto the
air connecting piece – Fig. 4 – and fasten the
exhaust pipe to it.
Preparing the wall
•
The wall must be flat and perpendicular.
2
2
•
Ensure that the wall is capable of providing a
firm hold for mounting screws and plugs.

Electrical connection

The extractor hood should only be connected to an
earthed socket that has been installed according
to relevant regulations. If possible site the earthed
socket directly behind the chimney panelling
Electrical Data:
Are to be found on the name plate inside the
appliance after removal of the filter frame. Before
undertaking any repairs, always disconnect the
extractor hood from the electricity supply.
Length of the connecting cable: 1,3 m
If it is necessary to wire the extractor hood directly
into the mains:
The extractor hood should only be connected to
the electricity supply by a properly qualified
electrician.
A separator must be installed in the household
circuit. A suitable separator is a switch that has a
contact gap of more than 3 mm and interrupts all
poles. Such devices include circuit breakers and
contactors.
If the connection cable for this appliance is
damaged, the cable must be replaced by the
manufacturer or his customer service or a similarly
qualified person in order to prevent serious inury to
the user.
This extractor corresponds to EC regulations
concerning RF interference suppression.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
IMPORTANT: Fitting a different plug.
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow – Earth
Blue – Neutral
Brown – Live
If you fit your own plug, the colours of these wires
may not correspond with the identifying marks on
the plug terminals.
9